Dynex DX-32L200A12 Manual De Instrucciones página 12

3.4 HDMI port
Input HDMI signal from signal generator VG849 with the formats as Table 6, check if the
display and the sound are normal.
4 User menu preset before leaving factory
Enter into factory menu, select Other Setting→ SHIPMENT, the TV set will perform preset
automatically, and the step must be done after the factory alignments have been completed,
main operations of SHIPMENT are described as below:
a) Clear out all programs information;
b) Clear V-CHIP information;
c) Analog value default setting for all sources;
d) Power on mode set to off;
e) Active Setup Wizard menu
Note: After user menu preset has been completed, it is necessary to exit menu, turn off the
TV set to standby mode, then cut off the power supply.
5 Instruction of factory software burning is shown as Table 7
Location
Part No.
No.
NS04 5272532005
Note : Write-protection setup method
Enter into interface AUTO of burning program ALL-100, mark item "Config" which must
be selected during burning process. Click item "Config Setting", set item "Protect" as
"All Protect", "SRWD" as "Enable", and write-protection must be re-set after burning
program ALL-100 startup every time.
6 Software upgrade from U disk
Software can be upgraded from U disk after the TV set is leaving factory, please refer to
options below for details:
Aligment Instructions
Table 7 Instruction of factory software burning
Part type
MX25L3205DM2C-12G
Software
Burning method
function
use tool like
Main write-protection
program please refer to Note below for
details
remark
ALL11 ect.,
is needed,
For all models