ENGLISH
1. PARTS Y COMPONENTS
Fig. 1
1. Main body
2. Control panel
3. Feet
4. On/Off switch
Please note:
The graphics in this manual are schematic representations and may not exactly
match the product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the
device out of its box and remove all packaging materials. You can keep the original
box and other packaging elements in a safe place. This will help you prevent product
damage when transporting it in the future. In case the original packaging is disposed
of, make sure all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If any
of them are missing or not in good condition, please contact the official EVVO
Technical Service immediately.
- Make sure the side power switch is set to the OFF position.
- Plug the device to an earthed wall socket.
3. PRODUCT ASSEMBLY
Floor assembly
Attach the feet support to the product's bottom part using the ST12 x 4 mm screws
provided as shown in figure 2.
Wall assembly
Warning:
When installing the product, make sure to leave a minimum safety distance of 15 cm
from the floor to the device and 50 cm from the ceiling.
1. Remove the installation bracket at the rear of the unit by removing the fixing screws
20
CONVECTOR EVVO C1000/C2000 CRISTAL NEGRO/BLANCO
