Idiomas disponibles
Idiomas disponibles
Owner Maintenance
This tape deck requires no lubrication.
Head Cleaning
Sound quality is greatly influenced by accumulation of magnetic
particles on the recording/playback head. For the clearest possible
sound, be sure to clean the heads periodically, normally 2 — 3 times
a month. A dirty head will cause:
e
Poor sound quality (loss of high frequencies)
@
Decreased volume
e
Skipping
e
Incomplete erasure of previous recordings
To prevent these problems, clean the heads and capstan shaft with a
cleaning pen or cotton swab dipped in a little alcohol.
Cassette door
ONE
YO
llegra Brero CAsse etl TAPe OLCK |
Capstan
Recording head
Playback head (©)
Erasing head
Pinch Roller
Pinch Roller Cleaning
Demagnetizing
Power Supply
Voltage Selector (on Rear Panel)
Some units are equipped with a voltage selector. If the unit you own
has a voltage selector, be sure it is set to the proper voltage before
the power is turned on. To change the selector to conform
to the
power supply in your area, insert the tip of a screwdriver in the
groove of the switch and slide it all the way to the left or right.
220V
120V
220V
120V
at AC 120V
at AC 220V
Note:
Units not equipped with a voltage selector can only be used in areas
where the power supply is the same as the voltage specified on the
rear panel.
FOR POWER CORDS WITHOUT PLUGS:
CAUTION
Replacement and mounting of an AC plug on the power supply
cord of this unit should be performed only by qualified service
personnel.
IMPORTANT: The wires in the mains lead are
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this unit may
not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
