Epomaker EK21 VIA Guía De Uso Rápido página 3

Q U I C K S T A R T G U I D E
Remove Switches
1. Grab your Switch Removal Tool and align the gripping teeth vertically (on the Y-Axis) at the
center of the switch, as shown in the example graphic above.
2. Grab the switch with the Switch Puller and apply pressure until the switch releases itself
from the plate.
3. Using firm but gentle force pull the switch away from the keyboard using a vertical motion.
Install Switches
1. Check that all the switch metallic pins are perfectiy straight and clean.
2. Align the switch vertically to have the Gateron logo facing north. The pins should align
themselves to the keyboard PBC.
3. Press the switch down until you hear a click. This means your switch clips have attached
themselves to the keyboard plate.
4. Inspect the switch to ensure it's properly attached to your keyboard, and test it.
Note: If the key doesn't work its possible you may have bent one of the switches while
installing it. Pull the switch out and repeat the process.
Pins may be damaged beyond repair and need replacement if this process is not done
correctly. Never apply excessive force when replacing keycaps or switches. If you
cannot remove or install keycaps or switches please contact customer service as soon
as possible to avoid damage to the keyboard due to operating errors.
FUNCTION KEY COMBINATIONS
Fn + Enter
Toggle Backlight Effect
Fn + 0
Reset the numpad
(Hold 3s)
Short Press to Switch
Fn + 1
to BT1;
Long Press to Pair Devices
Short Press to Switch
Fn + 2
to BT2;
Long Press to Pair Devices
Short Press to Switch
Fn + 3
to BT3
Long Press to Pair Devices
Short Press to Switch
Fn + 4
to 2.4G Mode;
Long Press to Pair Devices
Fn + 5 Backlight Sat +
Fn + 6 Backlight Sat -
Fn + 7
Backlight Speed -
Fn + 8 Backlight Speed +
Fn + +
Backlight Brightness +
Fn + -
Backlight Brightness -
Fn + / Backlight Hue -
Fn + *
Backlight Hue +
Fn+Backspace
Turn on/off Backlights
(Numlock indicator stays on and cannot be off)
EN