Idiomas disponibles
Idiomas disponibles
SETTING THE CLOCK
1
1
2
3
2,3
IL ,,—. . .-—
I
c)
d}-;
——. .—
,_
Press
the CLOCK
button
while
pressing
the
SHIFT button on the remote control, and press
the 11
SET button
within
4
seconds.
The hour flashes.
Press
the
l+<
DOWN
or
WI
UP
button
to
designate the hour, and press the II SET button.
The hour stops flashing and the minute starts flashing.
Press
the
M
DOWN
or M
UP button
to
designate
the minute,
and press
the II
SET
button.
The minute stops flashing on the display and the clock starts
from 00 second.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The clock is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch
to the 24-hour
standard
Press the
CLOCK
button while pressing the SHIFT
button on
~he remote control and then press the
button within 4 seconds.
'Repeat the same procedure to restore the 12-hour standard.
[f the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase may need to be
reset.
SETTING THE TIMER
1
6
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
Press-the
TIMER button on the remote, control
while pressing the SHIFT button once to display
0, and press the 1I SET button within 4 seconds.
O is
displayed; and the hour flashes:
If you do not press the II SET button within 4 seconds,
another operation may start.
Designate
the hour of the timer-on
time
by
pressing the -
DOWN or W
UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
Within
4 seconds,
press
one of the function
buttons to select a source.
"TIMER" and the selected source name flash alternately for
4 seconds.
If this step is not completed within 4 seconds, repeat from
step 1.
If the TUNER button is pressed, the band cannot be selected
in this step.
