Genius INVICTUS X7 Instrucciones De Uso página 30

GB
2. To remove the brush roller, release the lock and remove the side cover. (see fig. K)
3. Remove the brush roller from the side (see fig. L).
4. Wipe the brush roller or clean it under running water if necessary. Remove hair and other dirt.
5. Allow the brush roller to dry completely.
6. Replace the brush roller and put the side cover back on.
360° hard floor electric brush cleaning:
1. Wipe the housing with a damp cloth.
2. To remove the brush rollers, release the side lock and separate the rollers from the housing. (see fig. M)
3. Pull the brush rollers off the attachment. (see fig. N)
4. Wipe the brush rollers or clean under running water if necessary. Remove hair and other dirt.
5. Allow the brush rollers to dry completely.
6. Place the brush rollers on the fastening and push them back into the housing. (see fig. O)
Cleaning the motorised mini electric brush:
1. Wipe the housing with a damp cloth.
2. To remove the brush roller, loosen the side lock anticlockwise using a coin and remove the side cover. (see fig. P)
3. Pull out the brush roller sideways. (see fig. Q)
4. Wipe the brush roller or clean it under running water if necessary. Remove hair and other dirt.
5. Allow the brush roller to dry completely.
6. Replace the brush roller, insert the side cover and close it again clockwise using a coin.
Troubleshooting
Only for electrical appliances
WARNING!
Switch off the appliance and disconnect the mains plug before addressing any faults! Failure to do so may result in
injury or electric shock.
Problem
Appliance isn't working Battery is empty
Battery will not charge Appliance or charging station is
Suction power
decreases
30
Instruction manual
Possible causes
Brush roller is blocked
not correctly connected to a
power socket
Contact with charging station
has not been established
Suction opening on the container
is blocked
Dust container is full
Filters are dirty
Brush roller is blocked
Solution
Charge the battery
Clean the brush roller and remove debris such as hair
and fibres if necessary.
Connect the mains adaptor correctly to a functioning
power socket
Hang the hand-held appliance correctly in the charging
station
Clean the suction opening on the hand-held appliance
and check the suction tube for any dirt.
Empty the dust container
Clean the filters, replace the HEPA filter if necessary
Clean the brush roller and remove debris such as hair
and fibres if necessary.