Idiomas disponibles
Idiomas disponibles
ASSEMBLY
IMPORTANT:
Read entire owner's manual beforeyou
attempt to assemble or operate your new pressure washer,
Remove
Pressure Washer
from
Carton
o Remove the parts bag accessories_ and insert inchded
with pressure washer.
o Ske two corners at the end of carton from top to
bottom
so the panel can be folded down fht_ then
remove ail packing material.
o Roli pressure washer out of carton,
Carton
Contents
interns in the carton
include:
Main Unit
Goggles
Handle
High Pressure Hose
Spray Gun
Nozzle Extension
Oil Bottle
Parts Bag (which includes the following):
Owner's
Manual
Engine Manual
Owner's
Registration Card
Handle Fastening Hardware
Kit (which inchdes):
Carriage BoB
(2)
Plastic Knobs (4)
"L" Hooks (2)
PREPARING
PRESSURE
WASHER
FOR USE
[f you have any problems with the assembly of your
pressure washer or if parts are missing or damaged_ can the
pressure washer heipiine at i -888-6 i 1-6708. If calling for
assistance, please have the model revision, and serial
number from the model data decal available.
To prepare
your
pressure
washer
for
operation,
you
wH[
need
to perform
these
tasks:
I.
FiN out and send in registration
card.
2.
Attach handle to main unit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect
high pressure hose to spray gun and pump.
6.
Connect water
supply to pump.
Attach
Handle
[.
Place handle assemb[7 onto handle supports connected
to main unit. Hake sure holes in handle align with holes
on handle supports
(Figure [).
Handle
Supports
NOTE:
It may be necessary
to move the handle
supports
from side to side in order
to align the handle so it will slide
over the handle
supports.
2.
Insert carriage
bolts through
holes from outside
of unit
and attach a plastic knob from inside of unit (Figure 2).
Tighten by hand.
3.
Insert one "U' hook through hole just above billboard
on left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten
by hand.
4.
Insert other"U'
hook through hole just below
billboard on right side of handle (viewing from front of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten
by hand.
O
