Idiomas disponibles
Idiomas disponibles
Storage
PREPAPdNG THE
fJNmT
FOP, STORAGE
Water shouH not remain inthe unitforHongperiods of
time. Sedimentsor minerals can deposit on pump parts and
"freeze"
pump action. If you do not pHan to use the pressure
washer for more than 30 days, follow this procedure:
I.
Flush detergent
siphoning
tube by placing the filter into
a pail of clean water
while running pressure
washer
in
low pressure
mode (adjustable
nozzle in the forward
position).
Flush for one to two minutes.
2.
Shut off the engine and let it cool, then remove
high
pressure
and garden
hoses. Disconnect
spark plug wire
from spark plug.
3.
Empty the pump of all pumped
liquids by pulling the
recoil handle about
6 times.This
should remove
most
of the liquid in the pump.
4.
Use PumpSaver
to prevent
corrosion
build up and
freezing of pump.
5.
Store unit in a clean, dry area.
Protecting
the
Pump
To protect
the pump from damage caused
by mineral
deposits
or freezing, use PumpSaver
to treat pump.This
prevents freeze
damage and lubricates
pistons
and seals.
NOTE:
PumpSaver, model number 01559, is available as an
optional
accessory. [t is not included with the pressure
washer.
Contact
the nearest authorized
service center
to purchase
PumpSaver.
• Failure to do so will permanently
damage
your pump and
render your unitinoperable,
• Freeze
damage
is not covered
under
warranty.
CAUTION
Always wear eye protection when using PumpSaven
To use PumpSaver, make sure the pressure washer is
turned off and disconnected
from supply water. Read and
follow all instructions
and warnings given on the PumpSaver
container.
NOTE
t PumpSaver
will drip from pump after treatment
and will stain wood and concrete.
NOTE
t [f PumpSaver
is not available, draw RV antifreeze
(non-alcohol)
into the pump by pouring
the solution
into a
3-foot
section
of garden
hose connected
to inlet adapter
and pulling recoil handle twice.
STORING
THE ENGINE
See the engine
owner's
manual
for instructions
on how
to
properly
prepare
the engine
for storage.
