Idiomas disponibles
Idiomas disponibles
,_
WARNING: To prevent acci-
dental starting when making
any adjustments or repairs,
always disconnect the spark plug
wire and place it where it cannot
make contact with the spark plug.
ADJUST AUGER CONTROL CABLE
The auger control
cable is adjusted
at the
7.
factory.
During
normal
use,
the
auger
control
cable can become
stretched
and
8.
the auger drive lever will not properly
en-
gage or disengage
the auger.
1. Remove the "Z" hook from the au-
ger drive lever (Figure 18).
2. Slide the cable boot, if equipped,
up the auger control cable until the
cable boot does not cover any por-
tion of the cable adjustment
brack-
et (Figure 19).
3. Pull the auger control cable
through the eyehole in the cable
adjustment
bracket
as shown by
the arrow in Figure 19. This will
create enough slack to allow the
"Z" hook to be easily removed.
4. Install the "Z" hook into the next
available adjustment hole in the
cable adjustment
bracket.
This is
the adjustment hole located one
notch down from where the "Z"
hook was previously attached.
5. Pull the auger control cable back
through the eyehole of the cable
adjustment
bracket
until all the
slack is taken out of the auger con-
trol cable.
6.
Slide
the cable
boot
back down
over the cable adjustment
brack-
et.
Install the "Z" hook to the auger
drive lever (Figure 18).
To check the adjustment, start the
snow thrower. Make sure the auger
does not rotate when the auger
drive lever is released. Engage the
auger drive lever and make sure
auger rotates, if the auger does not
rotate, repeat this "Adjust Auger
Control Cable" procedure.
Auger
Drive
Lever
Z Hook
Figure 18
Auger Control
Cable
Cable
Boot
Cable Adjust-
ment Bracket
_Hook
Figure 19
F 041032C
18
