Idiomas disponibles
Idiomas disponibles
Parallel Guide with Circle Cutter (Accessory)
For cuts using the parallel guide with circle cutter 26
(accessory), the thickness of the material must not
exceed a maximum of 30 mm.
Parallel Cuts (see figure I): Loosen the locking screw
25 and slide the scale of the parallel guide through the
lead 24 in the base plate. Set the desired cutting
width as the scale value on the inside edge of the
base plate. Tighten the locking screw 25.
Circular Cuts (see figure J): Set the locking screw 25
to the other side of the parallel guide. Slide the scale
of the parallel guide through the lead 24 in the base
plate. Drill a hole in the workpiece centred in the sec-
tion to be sawn. Insert the centring tip 27 through the
inside opening of the parallel guide and into the drilled
hole. Set the radius as the scale value on the inside
edge of the base plate. Tighten the locking screw 25.
Coolant/Lubricant
When sawing metal, coolant/lubricant should be ap-
plied alongside cutting line because of the material
heating up.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean the saw blade holder regularly. For this, remove
the saw blade from the machine and lightly tap out the
machine on a level surface.
Heavy contamination of the machine can lead to mal-
functions. Therefore, do not saw materials that pro-
duce a lot of dust from below or overhead.
In extreme conditions, always use dust ex-
traction as far as possible. Blow out ventila-
tion slots frequently and install a residual cur-
rent device (RCD). When working metals,
conductive dust can settle in the interior of the pow-
er tool. The total insulation of the power tool can be
impaired.
Lubricate the guide roller 13 occasionally with a drop
of oil.
Check the guide roller 13 regularly. If worn, it must be
replaced through an authorised BTI after-sales serv-
ice agent.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for BTI
power tools.
In all correspondence and spare parts orders, please
always include the 7-digit order number given on the
nameplate of the machine.
2 609 932 692 • 29.10.09
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implemen-
tation into national right, power tools
that are no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Subject to change without notice.
English | 39
