Idiomas disponibles
Idiomas disponibles
POWER PACK ASSEMBLY INSTRUCTIONS
4. For low-voltage cable connections, split one end
of the power supply cable (H) approximately 2 in., and
strip about 3/4 in. of insulation off each wire, then twist
strands together tightly.
5. Distribute the light fixtures as evenly as possible
along power supply cable (H). Position the higher
wattage fixtures closer to the power pack (G) and
lower wattage fixtures away from it. Note: There
should be a minimum of 10ft. between the first light
fixture and the power pack (G).
6. Decide the distribution of lights and calculate the total
length of low-voltage cable that is needed to go around
and return to the terminal block of power pack (G).
Make sure not to cross the wires when routing them back
to the term ina I blocks. The wire coming out from a
particular terminal screw must go back in the same
terminal screw. Note: The wire has a smooth side and a
rigged side for identification.
Please make sure the cables are securely connected to
the terminal block of power pack (G) to prevent the risk of
fire, electrical shock or damage to the power pack (G).
7
12VAC OUTPUT
Lowes.com/portfolio
