Idiomas disponibles
Idiomas disponibles
Installation
Instructions
PREPARATION
TOOLS AND MATERIALS
YOU WILL NEED
• Saw
• Flat blade
screwdriver
• Electrician's
pliers
• Duct tape
• Measuring
tape or scale
• Carpenter's
square
• 7/16" wrench
or socket
set
• Drill
and drill
bit
• Sheet
metal
screws
• Junction
box*
• 3/4" flexible
conduit*
• Electrical
wire
per local
code*
• Wire
nuts*
• Duct work
*NOTE:
Electrical
installation
kit JXCK89
may be ordered
separately
and includes
all
the parts
necessary
to connect
the cooktop
to typical
rough-in
wiring.
-A CAUTION:
FOR PERSONAL
SAFETY,
REMOVE
HOUSE
FUSE OR CIRCUIT
BREAKER
BEFORE BEGINNING
INSTALLATION.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper
voltage and frequency, as listed in these Installation
Instructions, and connected to an individual,
properly grounded branch circuit, protected
by a 40-amp circuit breaker or time delay fuses.
All wire connections must be made in accordance
with local codes and properly insulated. Check with
your local utility for governing electrical codes and
ordinances. In the absence of local electrical codes,
the National Electrical Code, ANSIiNFPA No. 70 -
Latest Edition, governing
electric range installations,
must be followed.
A copy of the National Electrical Code can be
obtained by writing to:
National Fire Protection Association
Batterymarch
Park
Quincy, MA 02260
Effective January 1, 1996, the National Electrical
Code requires that new, but not existing,
construction
utilize a four-conductor
connection to
an electric range. When installing an electric range
in new construction,
follow the instructions
in NEW
CONSTRUCTION AND FOUR-CONDUCTOR
BRANCH CIRCUIT CONNECTION.
You must use a three-wire, single-phase AC
208Y/120 Volt or 240/120 Volt, 60 Hertz electrical
system with separate ground. If you connect to
aluminum wiring, properly installed connectors
approved for use with aluminum wiring must
be used.
30" COOKTOP
(DIMENSIONS
FOR REFERENCE ONLY)
Unit shown
fully assembled.
21%"
_
201_2"_
22 tt
T
297/8"
283/4"
=
2 H
A
Unit must be vented
to the outside!
15
