Idiomas disponibles
Idiomas disponibles
Power Supply
Connections
OPE/BATl-
The OPE/BATT
indicator lights up while electric current flows
to the unit.
Connect the AC cord as illustrated
below.
~+@
to an AC outlet
supplied AC cord
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Open the lid of the battery compartment
on the rear and
insert eiaht R20 (size D) batteries,
not sumiied,
as illustrated
below. ~hen close the lid.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
When the OPE/BATT
indicator becomes dim, the tape speed
slows down, volume decreases,
or sound is distorted during
operation,
replace the batteries.
Notes on batteries
To avoid damage frolm leakage or explosion,
observe the
following:
Insert the batteries with the O and O marks correctly
aligned.
Do not mix different types of batteries or old batteries with
new ones.
When the unit is not to be used for a long period, remove
the batteries.
Never recharge the batteries, apply heat to them or take
them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly
to remove.
IMPORTANT
Make sure that the AC cord is disconnected
and batteries
are removed before connecting
speakers.
Do not connect other than the supplied speakers.
Position the speakers.
To couple with the speakers,
slide each speaker down
into the guide brackets on the center unit until the height
is level with the unit.
To separate the unit from the speakers,
slide the
speakers up and off, while pressing the speaker release
knob.
Re
I
knob
I
Connect the speakers.
Connect the right speaker cord to the R terminals,
and
the left speaker to the L terminals.
Connect the speaker cord with the white broken line to
0 and the other cord to O.
ENGLISH
3
