Changing Paper In Setup Mode; From Fanfold Paper To Single Sheet Mode - Tally T2240/9 Instrucciones De Servicio

Quick start-up
Changing paper in
Setup mode
From fanfold paper
to single sheet mode
Online Trac.1
Load
Adjust Paperway
Menu Char
Tractor 1 *
Set Exit
Single
Set Exit
Tear paper off
Press any key
Offline Single
Park Load
When fanfold paper was in use and you want to change over to single sheet mode, proceed as
described below.
You do not need to remove the fanfold paper.
Cut the fed-out portion of the Continuous Form Feed Paper at the perforated line.
Online
To do this, proceed as follows.
Press the Setup
Setup
Press the Paperway
Online
Setup
< >
Press or to change to
Online
The currently valid setting
Setup
Confirm the setting by pressing the
Online
The input is acknowledged by an acoustic signal and the fanfold paper is trans-
ported to the tear position. Cut the fed-out portion of the Continuous Form Feed
Setup
Paper at the perforated line.
In the display appears...
Press any key.
Online
Setup
The printer returns to its initial status and the fanfold paper is transported to the
Online
park position.
The display toggles between...
Setup
and...
key. The printer changes to Setup mode.
key. The printer changes to the paper path menu.
Single (sheet) operating mode.
(Tractor 1) is marked by a "
Set key.
Settings (II)
*
".
19