Operation - Porter Cable PCB575BG Manual De Instrucciones

STARTING AND STOPPING THE GRINDER (FIG. M)
The "ON / OFF" switch has a removable, black plastic
key. With the key removed from the switch, unauthorized
and hazardous use by children and others is minimized.
1. To turn the grinder "ON", insert key (1) into the slot
of the switch (2), and move the switch to the "ON"
position.
2. To turn the grinder "OFF", move the switch to the
"OFF" position.
3. To lock the switch in the "OFF" position, grasp the
end, of the switch key, and pull it out.
4. With the switch key removed, the switch will not
operate.
5. If the switch key is removed while the grinder
is running, it can be turned "OFF" but cannot be
restarted without inserting the switch key.
CAUTION
!
Always lock the switch "OFF" when the grinder is
not in use. Remove the key and keep it in a safe
place. In the event of a power failure, blown fuse, or
tripped circuit breaker, turn the switch "OFF" and
remove the key, preventing an accidental startup
when the power comes on.
Fig. M
2
USING THE WORKLIGHT (FIG. N)
1. To turn the worklight "ON", rotate the worklight
switch (1) counterclockwise.
2. To turn the worklight "OFF", rotate the worklight
switch (1) clockwise.
Fig. N
1

OPERATION

1
CAUTION
!
• To avoid injury from an accidental start, make
sure the switch is in the OFF position and the
plug is not connected to a power outlet.
• To prevent injury resulted from heat of the light
bulb, never touch the light bulb until it has
completely cooled.
• To prevent electric shock, never touch any part
of the light bulb when the plug is connected to a
power outlet.
• It's recommended to use a vibration-resistant
light bulb for this grinder.
ADJUSTING THE SPEED OF GRINDER (FIG. O)
Your grinder is equipped with a variable speed control
knob. The speed of the grinder may be adjusted by
simply rotating the variable speed control knob (1).
1. To increase speed, rotate the variable speed control
knob (1) clockwise.
2. To reduce speed, rotate the variable speed control
knob (1) counterclockwise.
Fig. O
COOLING WORKPIECE (FIG. P)
The coolant tray (1) allows you to cool overheated
workpieces. Simply pull upward the tray and half fill with
appropriate coolant, such as water.
CAUTION
!
Do not overfill the coolant tray.
Fig. P
13
1
pointer
1