Idiomas disponibles
Idiomas disponibles
Installation
3.3 Before Installation
measurements are sufficient to receive the
product and that the appropriate electrical and
plumbing connections are present.
installation of the product. To make the product
ready for use, make sure that the electricity
installation is appropriate before calling the
electrician to have any necessary arrangements
carried out.
Part number of the filter is 4874960100 and
you can use this part number when ordering
replacement filters.
Preparation of the location and electrical
C
installation at the place of installation is
under customer's responsibility.
Plumbing: The refrigerator should only
C
be connected to the cold water line.
Product must not be plugged in during
B
installation. Otherwise, there is the risk of
WARNING:
connections of the product must be carried
B
Manufacturer shall not be held liable for
damages that may arise from procedures
carried out by unauthorized persons.
WARNING:
check if the product has any defects on
A
it. If so, do not have it installed. Damaged
products cause risks to your safety.
Installation and electrical
Prior to installation, visually
3.4 Appropriate installation location
from heat sources such as cooktops, ovens,
space heaters, radiators and stoves at least
2" (5 cm) away from electrical ovens. Product
kept in humid places after installation.
as rugs or carpets.
prevent wobbling.
temperature falls below 50F°/10ºC.
If two refrigerators are to be installed side
C
by side, there should be at least 1 1/2"
(4 cm) distance between them.
around the appliance to ensure free air
circulation.
gap of at least 1 3/8" (35 mm) between the
refrigerator and the rear wall. To ensure this,
attach the gray, circular buffers, to be installed
on the rear back metal cover of the refrigerator.
These are shipped inside the crisper drawer in
the Fresh Food compartment.
16 / 33 EN
Refrigerator / User Manual
