Idiomas disponibles
Idiomas disponibles
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove the
wire tie from the power cord.
Lock the cord into
place by forcing it
into the locking notch
on the body of the
quick release upper
cord hook as shown.
This helps keep the
Powor
power cord out from
under the vacuum
cleaner agitator.
Quick Release
Upper Cord Hook-
Lower
Cord Hooks'
II1_
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.
HANDI-MATE JR.®
For operation of Handi-Mate
Jr.® see
seperate owners manual.
Latch
,Caddy
HandloMate Jr.®
TO INSERT
HANDI-MATE
JR ®
Place the rear of the Handi-Mate Jr.® into
the caddy.
Rotate the Handi-Mate Jr.®back until it
snaps into place.
TO REMOVE
HANDI-MATE
JR."
Rotate Handi-Mate Jr.= out of the caddy.
HOW TO START
Release
Upper Cord
Hook
Turn the quick
release upper
cord hook to
either side
and down to
release the
power cord.
Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Check to be sure
the power cord is still locked into the lock in
the quick release upper cord hook.
Note: To reduce the risk of electric
shock,
this vacuum cleaner has a polarized
plug,
one blade is wider than the other.
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician
to install the
proper outlet. Do not change the plug in any
way.
Plug the polarized power cord into a 120
Volt outlet located near the floor.
WARNING
Personal Injury and Product Damage
Hazard
DO NOT plug in if switch is In the ON
Personal injuryor damage
result.
• DO NOT use outlets above counters.
Damage from cord to items in surround-
Ing area could occur.
6
