Tabla de contenido
Idiomas disponibles
Idiomas disponibles
● To detach the miter saw from the stand, confirm the cutting head is pulled forward and locked in the down position,
then unlock the mounting bracket cam latches while holding the miter saw firmly by hands to prevent the miter saw
from falling down from the stand rails. Remove the miter saw with the mounting brackets carefully with the help of
two or more people.
● When transporting the stand in a vehicle, securely tie it down to prevent movement and possible damage.
● To reduce the risk of injury, periodically check that all fasteners are attached and adjusted according to the assembly
instructions included in this manual.
● When service the stand, use only identical metabo HPT replacement parts. Repairs should be conducted only by a
metabo HPT authorized service center.
SAVE THESE INSTRUCTIONS AND MAKE THEM AVAILABLE TO OTHER USERS AND
OWNERS OF THIS STAND.
UNPACKING YOUR STAND
This product requires assembly.
1. Remove the stand and all parts from the carton.
2. Place the stand on the ground.
3. Separate all parts from the packing material. Check each one with the list below and illustration on page 6 to make
certain all items are accounted before discarding any packing material.
If any part is missing or damaged, do not attempt to assemble the stand until the missing or damaged part is correctly
replaced.
TABLE OF LOOSE PARTS
ITEM
A
Stand
B
Miter saw mounting bracket
C
Extension arm support assembly
D
Auxiliary mounting bracket
E
Bracket Stopper hardware bag
F
Wheel
G
Wheel shaft
H
Wheel hardware bag
I
Auxiliary mounting brackets hardware bag
J
Anchor plate
NOTE: In case of missing or damaged parts, please contact metabo HPT at (800) 546-1666 for assistance.
CARTON CONTENTS
WARNING
DESCRIPTION
– 5 –
English
QUANTITY
1
2
2
2
1
2
1
1
1
2
Tabla de contenido
