Idiomas disponibles
Idiomas disponibles
Maintenance
Keep the washer clean for best performance and to lengthen its life cycle.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric
shock only during servicing. Service personnel – Do not contact the following parts while
the appliance is energized: Control board, heat sink, motor, inlet valve and pump.
Self Clean
Certain usage and environmental conditions may result in some residue build-up or odor
in the washer drum. To prevent this build-up of residue or odor causing bacteria and keep
your washer drum fresh and clean, perform the SELF CLEAN cycle at least once a month
or every 40 cycles. Perform the recommended procedure below when using the SELF
CLEAN cycle.
1. Remove all items from the washer drum and ensure the drum is empty. Laundry left in
the drum during the SELF CLEAN cycle may be damaged.
2. Press Power to turn on the washer.
3. Turn the Cycle Selector to SELF CLEAN .
4. Press and hold Start/Pause (Hold to Start) .
NOTE
• The water temperature for SELF CLEAN is defaulted to Hot. This temperature cannot
be changed.
• In the case where residue is present in the washer drum, add liquid chlorine bleach to
the MAX level line in the main-wash compartment before starting the SELF CLEAN
cycle. Do not add the liquid chlorine bleach to the bleach compartment (This is only the
case for SELF CLEAN cycle).
• Do not exceed the max line. Do not use or mix any other detergent or chemicals during
the SELF CLEAN cycle. If necessary, run a RINSE+SPIN cycle after the SELF CLEAN
cycle has completed to help remove any remaining residue.
CAUTION
If there is chlorine bleach left in the washer drum for an extended period of time, rust can
occur.
SELF CLEAN reminder (
• After 40 washing cycles, the SELF CLEAN LED reminder icon and the SELF CLEAN
cycle LED will blink on the control panel for an hour and then turn off automatically.
• The reminder will appear on the control panel for 5 additional consecutive cycles
before turning off. The next reminder will not appear until another 40 cycles have been
completed.
40
English
)
