Idiomas disponibles
Idiomas disponibles
User Manual
Press once on the plastic inner frame at the other side of the housing until it pops out:
Insert the M.2 NVMe SSD(s) into the product, gently press down the M.2 SSD(s) and snap it into the
rubber plug.
Paste the thermal conductive pad on the SSD and finally the thermal conductive plate on top (please
remove the surface layers on both sides first). Finally push the plastic frame back into the Aluminium
housing and lock the secure lock E by sliding the switch to the left.
Please note: If you want to clone SSDs, do not connect the USB 3.2 Dual M.2 NVMe SSD Enclosure to
your computer
Offline Clone Operation
Install two M.2 NVMe SSDs* (the storage capacity of disk B (target disk) should be larger or equal to
disk A (source disk), then connect the power supply to the enclosure.
Press and hold the clone button A for about 3 seconds until all 4 blue LEDs light up, then release the
button and quickly press it again, offline clone begins.
4 indicators of progress light up in blue when offline cloning is in progress, 25% > 50% > 75% > 100%
flickers in turn, all 4 indicators light up when offline clone is done.
English
