D E FROSTI N G
The surface of the evaporator ices up when the refrigerator is working. This is an entirely normal
part of the operation. If the frost layer is more than 3mm (1/8") thick, the refrigerator must be de-
frosted and cleaned to avoid unnecessary energy consumption and inefficient operation.
• Remove all of the items from inside and unplug the refrigerator.
• After defrosting, clean the refrigerator and allow it to dry.
• Reconnect to the mains supply and turn the fridge on.
WARNING: Food should not be stored in the freezer in contact with its wall. When the surface of
the evaporator freezes it creates a thin layer of ice that would end up turning anything in contact
with this part of the freezer into a block of ice, which would also hinder the correct functioning of
the product.
R E PL ACIN G TH E LE D L IGH T B ULB
Your fridge uses a long-life, energy-saving LED lightbulb. Should you need to replace this light, please
contact your nearest retailer or service agent for a suitable replacement part.
To replace the lightbulb:
1. Disconnect the appliance from the power supply.
2. To remove the light shield, gently squeeze the light shield and slightly turn it deasil, then remove
the screws on both sides.
3. Gently pull out the connectors and take out the light box, but keep the controller and the ther-
mostat knob.
4. Insert the connectors into the new light box, place the controller and thermostat knob back, and
fasten them.
5. Put the light cover back and adjust it by turning it widdershins.
FOO D STOR AGE
1. The refrigerator compartment is suitable for short-term storage of fresh food. The internal tem-
perature of the appliance may be affected by the ambient temperature, frequency of door open-
ing, as well as the location of the appliance. When setting the temperature , these factors should
be taken into consideration.
2. In order to maintain good cooling efficiency and save energy, we recommend you do not open the
door for too long or too often. Do not overload the fridge, and leave enough space around items to
allow cold air to flow. Do not block ventilation openings.
3. The shelves can be positioned to suit individual storage requirements.
4. In order to keep vegetables fresh and crisp, make sure they are properly packaged and the cover
sits firmly on top of the crisper drawer (applicable model).
5. You can conveniently store two wine bottles in the hanging wine rack. If you don't need this wine
rack, or you wish to remove it for cleaning, pull the shelf that holds the rack completely out of the
fridge, then slide the wine rack off the side of the shelf (applicable model).
E NG LI SH
9