Create FRIDGE RETRO Manual Del Usuario página 7

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
U NPAC K I NG
• This product has been packaged to protect it against transportation damage. Remove all packag-
ing materials from around and inside the appliance, but do not remove any foam insulation sur-
rounding the pipes at the back. Keep the original packaging and materials in a safe place; this will
help prevent any damage if the product needs to be transported in the future, and you can use it
to store the appliance when it is not in use. In the event that the packaging is to be disposed of,
please recycle all packaging materials where possible.
• Plastic wrapping can constitute a suffocation hazard for pets, babies and young children. Ensure
all packaging materials are out of their reach and disposed of safely.
• Parts: Check to ensure you have all the parts shown at the beginning of this manual.
• Unwind the power cord completely and inspect it for damage. Do not use the appliance if the
refrigerator or its cord have been damaged or if they are not working properly. In case of damage,
contact our aftersales service.
• Make sure the refrigerator is disconnected from the power supply before cleaning the interior sur-
faces and all internal accessories with lukewarm water, a soft cloth and neutral cleaning agents.
This will remove any dust from transit and storage and will help remove the typical smell of a
brand new product. Dry thoroughly. Important: do not use harsh or abrasive detergents or powders,
as these will damage the finish.
D OO R H AN D LE IN STALL AT I ON
The door handle comes detached due to packaging restrictions. It can be easily attached following
the instructions.
• Fix the two screws (1) to the door.
• Insert the two fixed screws into the two holes on the metal handle (2).
• Fasten the two screws (3) to the bottom of the handle.
FR IDGE IN STALL AT I ON
Before installing your new fridge, read all of the safety guidelines in this manual and then follow the
instructions below:
1. Place the fridge on a sturdy, level floor for quieter operation. Ensure that the floor is strong enough
to support the fridge when it is fully loaded.
2. If the refrigerator is to be placed on a carpet, put a wooden board in between the fridge and the
carpet. Be aware that, by placing the refrigerator on top of a carpet, the heat from the compressor
may cause the carpet to fade.
3. This appliance is designed to be freestanding and it should not be recessed or built-in.
4. Do not tilt the fridge more than 45° from its upright position when moving it.
LET'S GET STARTED
1
1
2
3
3
E NG LI SH
7
loading