cecotec CONGA ROCKSTAR DEEPCLEAN WET Manual De Instrucciones página 52

ENGLISH
Charge and display
- The battery must be charged with the wall bracket while it is connected to the main body.
Plug one end of the adapter into the power supply and connect the other end to the bracket.
- During charge, the battery indicator will flash. When charging is complete, the battery
indicator will remain steady.
- You can also charge the battery without using the wall bracket. You can charge the battery
when the battery is installed or not in the vacuum cleaner. Connect the adapter and connect
the other end to the battery, paying attention to the direction. Once properly connected,
the battery indicator will flash and change to steady when charging is complete.
5. WATERTANK ACCESSORY
- Do not use cleaning agents. Use clean and room temperature water only. Do not use the
vacuum cleaner to vacuum water.
- When the vacuum clener is not going to be used for a long period of time, remove the
water tank and empty the remaining water. Do not expose it to direct sunlight or to damp
environments.
Mop installation
- Place the mop cloth on the ground with the Velcro facing upwards.
- Align the mop cloth with the Velcro strips on the water tank and attach it without covering
the wheels.
Replacing the mop
- Remove the water tank from the vacuum cleaner.
- Replace the mop and refill the water tank.
- Install the water tank again, insert the tank in the lower part of the vacuuming brush head,
and press until it is fixed.
Water emission
- When using this product for the first time, make sure the water tank lid is not fully open.
- When the product is not in use, check that the cap is closed, as the product may continue
to let out water if the water tank is full.
6. CLEANING AND MAINTENANCE
- Turn the appliance off, unplug it from the power socket, and allow it to cool down before
cleaning it.
- Use a soft, slightly dampened cloth to clean the surface of the device.
52
CONGA ROCKSTAR DEEPCLEAN WET