Idiomas disponibles
Idiomas disponibles
Texi Black Turbo
POURING WATER INTO THE TANK
The system monitoring the water level in the tank activates when the water level drops below
the minimum. The system will remind the user of the need to replenish water by activating a
sound signal, and the "no water" lamp will light up.
MAINTENANCE
IMPORTANT WARNING Before opening the drain valve, remember to switch off the appli-
ance, remove the plug from the power socket and leave the appliance to cool for 2 hours.
Pour out the water that has gathered in the appliance's basin. The pressure gauge must indi-
cate a zero value.
Mineral sediments that occur naturally in water leave white sediments in the steamer, which
may affect the appliance's performance. It is strongly recommended to clean the appliance
every 3 months. Using a 14mm key, open the drain valve found at the bottom of the appliance
and empty the steam boiler.
STEAM HEAD CLEANING SYSTEM
1. Plug the appliance, switch on power, then
release the button at the end of the steam
head's holder (DESCALING) to switch off the
heater and start the cleaning process.
Head work modes:
Button pressed: head heater is switched on
Button released: head heater is switched off
2. Place the appliance near a sink or prepare a
bowl into which sediments from the steam head
will flow out, insert the head into the container,
with the holes in the foot facing down.
The cleaning process ends when polluted water
is no longer flowing out of the steam head, this
lasts about 4-5 minutes.
3. Press the button at the ends of the steam head's holder. The heater will switch on. The
appliance will start working properly after 1 minute of waiting, when the steam pressure
reaches 4 bar or the steam lamp lights up. Press the steam button and start normal work.
www.TEXI.info
24
