Yissvic MK1000-UL Manual De Instrucciones página 8

TROUBLES SHOOTING
Problems
Indicator light doesn't work
or frother doesn't work
Stop working after the
device starts
Motor doesn't work
No heating
Charring
Milk foam is not up to
standard
Causes
Plug is not inserted
properly
The milk frother and the base
are not in good contact
No power in the socket
Problems with electric elements
Temperature of machine body
is too high
Milk frother damaged with
immersion in water
Milk frother is not cleaned in time
after use, milk locks
the mechanism
Motor damage
Machine damage
Dosage of milk either too
little or too much
Milk frother reused without
cleaning
The actual use voltage is
significantly higher than the
rated voltage
Wrong milk type or temperature Make sure to use whole or
The whisk is not inserted
Body reused without cleaning
-EN.07-
Solutions
Re-insert into the
power
Remove the milk frother and
place again on the base
Check the electric circuit
Repair
Rinse the inside of body with
cold water to reduce the
temperature
Repair
Clean and move the shaft
sleeve of motor by hand
to loosen it
Repair
Repair
Use the dosage of milk
according to the dial
Cleaning in time after use
Use the appropriate voltage
semi-skimmed milk at
refrigeratortemperature
(about 6-8 °C)
Make sure to insert the whisk
Make sure the body is clean