S&P KIT SILENT-100 ECOWATT 12V Manual Del Usuario página 10

ENGLISH
KIT SILENT / KIT SILENT DESIGN
ECOWATT 12V + CT-12/6
The SILENT extractor fan range is
manufactured to the high standards of
production and quality as lay down by he
international Quality Standard ISO 9001.
All components have been checked and
every one of the final products will have
been individually tested at the end of the
manufacturing process.
Please read this instructions booklet
carefully before installing or starting up
the product. It
information on personal and user safety
measures to be followed while installing,
using and carrying out maintenance work
on the equipment.
Important information
- Check that the apparatus is in perfect
condition while unpacking. Any fault or
damage caused in origin is covered by
the S&P guarantee. Please make sure
that the apparatus coincides with the
product you have ordered and that the
details on the instructions plate fulfil
your necessities.
- Installation must only be carried out by
qualified persons.
- Make sure that
complies with each country's current
mechanical and electrical norms.
- If a ventilator is going to be installed to
extract air from premises where a
boiler or other combustion apparatus
are installed, make sure that the
building has sufficient air intakes to
assure adequate combustion.
- The extractor outlet must not be
connected to a duct used to exhaust
smoke or fumes from any appliance
that uses gas or any other type of fuel.
10
contains important
the installation
- This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children shall not play with
the appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Installation fig.1
IMPORTANT: Before
wiring the unit, ensure that the main
supply is switched off.
1 : Protection grille
2 : Connec ion terminals
3 : Outlet with backdraught shutter
4 : Cable entry
The SILENT can either discharge directly
to the outside or via an individual or
central ducting system (see Fig. 2).
The unit can be mounted on the wall or
ceiling using the 4 rubber blocks and the
screws provided.
Drill a hole in chosen position in the wall
or ceiling of 105 mm dia.
If the unit is to be installed with individual
ducting, use a standard duct 100 mm dia.
Loosen the screw (2), which holds the
grille in place (1) and remove the grille.
installing and