Concept OV2000 Manual Del Usuario página 57

CONTROL
USE
1. Connect the dehumidifier to the mains.
2. Press the on/off button
3. When the automatic mode is launched, the LED lights up.
4. Use the Mode button to set the desired operating mode. Each time the Mode button is pressed, the corresponding
LED lights up and the operating mode changes. Press and hold the Mode button for 5 seconds to activate the lock.
Hold the button again to deactivate the lock.
5. If the value on the display does not flash, it shows the current humidity level.
HOW TO STOP OPERATION
Press the on/off button to stop the operation, all LEDs will go out. (Warning: Do not disconnect the appliance from the
mains during operation. Always turn the appliance off first. Then pull the power cord out of the socket. Otherwise it
may damage the electrical components and shorten the life of the appliance.) Finally, close the flap (only for models
without the angular function).
OPERATING MODES
Press the mode switch and select the desired operating mode. The order of the modes is as follows:
Automatic mode
Note: When the automatic mode is set as a default mode for the first time, the system stores the last selected operating
mode.
0 OV2000
Press the OSC button and
adjust the angle of the air
outlet flap.
Press the Air Clean button
Press the Timer button to
to launch the air cleaning
set the operation time.
mode.
Silent mode
AUTO SILENT
During defrosting process, The LEDs will light up and
the diodes will light up and the dehumidifier will stop
the dehumidifier will stop operating automatically as
operating temporarily. soon as the water tank is full.
Press the button to launch
Press the Mode button
the operation, press the
and select the operating
button for the second time
mode.
to stop the operation.
Drying mode Continuous mode
DRYING
EN
CONTINUOUS
57