Idiomas disponibles
Idiomas disponibles
Installation
Note!
First complete the electrical connections, and then check them for correctness. Unit should be installed
horizontally in an angle less than 30°
Installation
• Bend the 2 locking tabs of the Half Sleeve a little bit inside and insert the Half Sleeve into dash-board
hole, and then bend mount tabs outwards to fix it.
• If necessary, place the mount strap at the rear of the unit and fix it with provided washer.
• Push the unit into the Half Sleeve until you hear a click sound.
• Place Trim Ring over the unit and installation is completed (Some vehicle may not need Trim Ring).
Un-Installation
• Remove Trim Ring and insert Release Keys into left and right side-end holes as shown below and pull
the unit out of the dash-board.
GROUND ZERO
4
Control panel
1
Power / Mute button
2
Volume knob
3
T-Up / Next / Fast forward button
4
T-Dn / Previous / Fast backward button
5
Memory button
6
OK / PTY button
7
Mode button
8
Select button
9
Band / TA button
GROUND ZERO
10
IR Sensor
11
Aux in Jack
12
USB jack
13
Open button
14
SD Slot
15
Eject button
16
Light indicator
17
Reset button
18
Disc slot
5
