Idiomas disponibles
Idiomas disponibles
BOTTOM INSTALLATION POSSIBILITIES
100mm
INSTALLATION
TIP
We recommend installing the sensor permanently once it has been connected to the awning.
Remove the covers by pulling them upwards.
Hold the sensor in the correct position.
Mark the drill holes.
Drill the marked spots with a Ø 6 mm drill bit (based on the surface, make sure
you use the correct type of drill bit).
Insert the wall anchors.
Securely attach the sensor using the provided screws.
You can also use the included mounting plate, which allows installation without drilling.
You can attach it using any mounting adhesive available in specialized stores.
NOTE
The facade plaster does not provide sufficient adhesion for mounting
adhesive and the weight of the sensor! No responsibility can be
assumed for durability on such surfaces.
WARNING
Before drilling, the mounting surface must be examined to ensure there are no hidden pipes (water,
electricity, and gas should be checked). There is a risk of water damage, electrocution, and explosion.
195mm
11
ENGLISH
100mm
