WMF SKYLINE Instrucciones De Uso página 12

12
Descaling
Limescale deposits lead to losses of energy and impair the service life
of the device. It shuts off prematurely if the limescale layer is too
thick. It can then only be removed with great difficulty. Therefore
descale regularly.
We recommend using durgol
non-abrasive.
You can find this where the device was purchased, in select speciality
stores or you can order it directly from wmf consumer electric.
Prior to descaling, unplug the device and allow it to cool. Fill with 1
to 2 cups of durgol universal and leave the device until the limescale
®
layer on the bottom is removed. Then fill the device with cold tap
water to cover the limescale ring on the wall and allow to stand for 15
minutes. Then pour out and thoroughly rinse with cold tap water. Do not heat the solution during descaling.
Attention: there is no claim under warranty for damages caused by not
observing the descaling instructions.
Causes for malfunctions
▪ Device switches off before boiling:
Bottom of the pot is too strongly calcified,
it is not filled with enough water
▪ Device will not switch on:
The device has not sufficiently cooled down following operation
with no or too little water.
If it is not possible to fix this problem, submit the device for repair.
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363
fitted to the mains lead. If the plug is unsuitable for your socket
outlets or needs to be replaced, please note the following. If the
plug is a non-rewireable one, cut it from the mains lead and imme-
diately dispose of it. Never insert it into a socket outlet as there is a
very great risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be done
according to the following instructions:
Warning - This appliance must be earthed
Important: The wires in this mains lead are coloured in accordance
with the following code:
green/yellow Earth
blue Neutral
brown Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:As the colours of the wires in the mains
lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
⋅
the wire which is coloured green and yellow must be con-
nected to the terminal which is marked with the letter E or by
universal. This is highly effective and
®