Idiomas disponibles
Idiomas disponibles
USE
COMPONENTS
1 Clipper
2 Set of blades for hair, 46 mm
3 On/off switch
4 Cutting length selector
5 Socket for transformer
6 Base
7 Guide combs
8 LED charge control
The appliance can operate either using mains power or in cordless mode, as it has a
rechargeable battery.
MAINS POWER SUPPLY
Connect the transformer the (fig.1- ref. 9) by inserting the plug into the appliance socket
(fig.1 - ref.5). Plug the transformer into the mains.
Warning: if the appliance does not work with mains power when the battery charge has run down
completely, switch it off, recharge the battery for about five minutes and then switch back on
again, running on mains power.
BATTERY OPERATION
• Only recharge the battery when you note a clear reduction in appliance power.
• When the battery is fully discharged, the appliance automatically switches off.
RECHARGING THE BATTERY
• The battery must be fully charged before using the device for the first time
• Switch off the appliance using the switch (fig.1 - ref.3). The battery can only be charged when
the appliance is switched off.
• Connect the transformer (fig.1 - ref.9) by inserting the plug into the appliance socket
(fig.1 - ref.5).
Or connect the transformer to the base (fig.1 - ref.6) by inserting the plug into the base plug
(fig.1 -ref.5), then place the appliance on the base.
• Plug the transformer into the mains.
• During battery charging the red light comes on (fig.1 - ref.8).
• When urgently needed, it is not required to wait for the end of the charging process.
• When fully recharged, the red light (fig.1 - ref.8) switches off.
• When the battery is fully charged, the appliance can be used up to 100 minutes without
connection to the mains.
• After a certain number of operating hours, charge duration in cordless mode may decrease
significantly.
• The maximum charge level is reached after 4 - 5 recharging procedures.
ADJUSTING THE CUTTING LENGTH
The appliance is equipped with the VARIO-CUT SYSTEM, which allows the selection of 5 different
cutting lengths (fig.2) using the proper selector (fig.1 - ref.4).
CUTTING WITH GUIDE COMBS
Depending on the type of cut desired, the appliance can be used with or without a guide comb
(fig.1 - ref.7). Guide combs are used to achieve different cutting lengths ranging from 3 to 20 mm.
FITTING AND REMOVING THE GUIDE COMB
• Switch off the appliance.
• To fit the guide comb, slide and push it into place (fig.3, A).
• To remove it, do the reverse operation (fig.3, B).
CHANGING BLADES
• Switch off the appliance.
• To remove the blades, push them out of their slot from underneath (fig.4).
• IMPORTANT: to replace the blades, set the selector (fig.1 - ref.4) to "3.0" (fig. 5); first
insert the rear part into the slot (fig.5, A), then push the front to close it (fig.5, B).
IMPORTANT: before fitting the blade, make sure that the motor pin (fig.7 - ref.1) is adjusted so
that it can slot into the space on the inner side of the blade (fig.7 - ref.2).
CABLE REEL
The base (fig.1 - ref.6) has a compartment where part of the cable can be wrapped if the full
length is not required (fig. 8).
9 Charger
10 Cleaning brush
11 Lubricating oil
12 Beard and moustache blade set
(optional; not supplied with the appliance)
13 Sculpting blade set
(optional; not supplied with the appliance)
8
