Checking The Wheel Lug Nuts; Adjusting The Tracking - Toro TimeCutter Max Manual Del Operador

Cortacésped giro cero de asiento de 127 cm (50")
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Checking the Wheel Lug Nuts

Check and torque the wheel lug nuts to 108 N∙m (80 ft-lb).

Adjusting the Tracking

When driving the machine forward full speed across a flat, level surface, if the machine pulls
to 1 side, adjust the tracking.
If the machine pulls to the left, adjust the right motion-control lever; if the machine pulls to
the right, adjust the left motion-control lever.
Note:
You can adjust the tracking only for driving forward.
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Locate the tracking-adjustment bolt near the motion-control lever on the particular side
that needs adjusting.
4. Rotate the bolt to decrease the speed for that particular wheel.
Note:
5. Start the machine and drive forward across a flat, level surface with the motion-control
levers fully forward to check if the machine tracks straight. Repeat the procedure as
needed.
Maintenance: Drive System Maintenance
Rotate the bolt a small amount to make minor adjustments.
position.
ARK
G451231
Page 5–21
3465-589 A
Tabla de contenido
loading

Este manual también es adecuado para:

77505

Tabla de contenido