Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND CARE
- WARNING! Always remove the battery from the
machine before carrying out work on it.
- Checking the saw blade: deposits of resin and
glue on the saw blade cause inefficient cutting.
To avoid them, always clean the blade immedi-
ately after use.
- Inspect the mounting screws: regularly inspect
all the mounting screws and ensure they are
firmly tightened. Should any screw be loose,
tighten it immediately. Failure to do so could put
you at serious risk.
- Motor maintenance: always take the greatest
care over this and make sure that the motor
winding is not damaged and does not become
wet with oil or water.
- The vents should always be kept clean and free
of obstacles.
- Clean the machine thoroughly after each use.
Blast the motor regularly with compressed air.
- Check that the mains lead is in good condition.
If it is not, take it to an Official Service Centre to
have it replaced.
CLEANING
- Disconnect the battery from the appliance and
allow it to cool before undertaking any cleaning
task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.
- Some of the accessories such as saw blades
are universal.
- Check our website for more information.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.
SPECIFICATIONS:
Rated voltage
Rotation Speed:
LED worklight
Number of LED's
Pendular positions: 4
Carbon brush motor:
Adjustable base:
Stroke height:
Max. Cutting depth (Steel):
Max. Cutting depth (Wood):
Max. Cutting depth (Plastic): 40 mm
Connection Type:
Quick change blades:
Lock button:
Base material:
Battery Connection: Slide on
Sound Pressure level (LpA) = 76.1 dB(A), KpA =
3 dB
Sound Power level (LwA) = 87.1 dB(A), KWA =
3 dB
Vibration= 7,918 m/s2, K= 1,5 m/s2
NB: These specifications are subject to change
without notice of purpose of improvement.
NB: By virtue of the conditions of fabrication of
this product, the maximum absorbed power can
differ from that specified.
NB: By virtue of the conditions of fabrication of
this product, the maximum used power can differ
from that specified.
- Measured sound level determined according EN
62481-1.
- The vibration emission level given in this infor-
20V
0-2500 min-1
Yes
1
Yes
Yes
20 mm
8 mm
65 mm
T-shank
Yes
Yes
Steel
