Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-X262 Manual De Instrucciones

GETTING STARTED

For key layout on the faceplate, see page 3 or page 4.
1

Cancel the demonstration

When you turn on the power for the first time (or after you reset the unit),
the display shows:
KD-X262/KD-X162:
"CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
KD-X161:
"CANCEL DEMO" "PRESS ENTER"
1 Press * ENTER.
[YES] is selected for the initial setup.
2 Press * ENTER again.
"DEMO OFF" appears.
2

Set the clock and date

1 Press and hold .
2
Perform 'Select an item (page 3 or 4)' operation to select
[CLOCK].
3
Perform 'Select an item (page 3 or 4)' operation to adjust the
clock.
[CLOCK ADJUST] set the hour and minute
[12H] or [24H]
4
Perform 'Select an item (page 3 or 4)' operation to set the date.
[DATE SET] set the day, month and year
5 Press to exit.
[CLOCK FORMAT]
To return to the previous setting item, press
3

Set the basic settings

1 Press and hold .
2 Perform 'Select an item (page 3 or 4)' operation to select an
item (see the following table).
3
Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
[SYSTEM]
[KEY BEEP] [ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]* [ON]: Enables AM in source selection. ; [OFF]: Disables. (Page 6)
[BUILT-IN AUX]* [ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 8)
[F/W UPDATE]
[UPDATE SYSTEM]
[F/W UP xxxx] [YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<http://www.jvc.net/cs/car/>.
* Not displayed when the corresponding source is selected.
.
.
Default: [XX]
5
ENGLISH