Maintenance - Panasonic SC-HTE80 Instrucciones De Funcionamiento


Main unit displays
"F61"
• There is a problem with the amplifier of the system.
• Disconnect the AC mains lead and consult the dealer.
"F70 HDMI"
• Check HDMI connection.
• Switch off the system and then switch it on again.
• Disconnect the HDMI cable.
"F76"
• There is a problem with the power supply.
• Disconnect the AC mains lead and consult the dealer.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Switch on this system.
2
Press and hold [1] on the main unit for a
minimum of 4 seconds.
3
Release [1].
"RESET" is shown.
All the settings are set back to the factory preset.
Note:
The remote control code will set back to "REMOTE 1"
after memory reset, refer "Remote control code" on how
to change to "REMOTE 2".
12
12
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
• Switch off all other Panasonic products.
• Switch on this system.

To set the code to "REMOTE 2"
Press and hold [MUTE] and [OK] for a minimum of
4 seconds.
"REMOTE 2" is shown.

To set the code to "REMOTE 1"
Press and hold [MUTE] and [T] for a minimum of
4 seconds.
"REMOTE 1" is shown.

Maintenance

To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean
this system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.