Idiomas disponibles
Idiomas disponibles
Important
Do not use the Vacuum-Blower to suck up water or very wet debris.
Never operate the Vacuum-Blower without the debris collection bag fitted.
Operating the Vacuum-Blower
Blower mode
Inspect the area to be worked before starting. Remove any objects or debris that
could be thrown, jammed or become entangled in the Vacuum-Blower.
Select the blow function using the selector lever on the side of the machine and switch on.
With the Vacuum- Blower resting on its wheels move the Vacuum-Blower forwards directing
the nozzle at the debris to be cleared.
Alternatively hold nozzle just above the ground and swing the machine from side to side,
moving forwards and directing the nozzle at the debris to be cleared. Blow the debris into a
convenient heap then use the vacuum function to collect the debris.
Vacuum mode
Inspect the area to be worked before starting. Remove any objects or debris that could be
thrown, jammed or become entangled in the Vacuum-Blower. Select the vacuum function
using the selector lever on the side of the machine and switch on. With the Vacuum-Blower
resting on its wheels move the Vacuum-Blower forwards directing the nozzle at the debris
to be collected. Alternatively with the Vacuum-Blower held just above the ground swing the
machine from side to side, moving forwards and directing the nozzle at the debris to be
collected. Do not force the nozzle into the debris as this will block the suction tube and
reduce the efficiency of the machine.
Organic materials such as leaves contain a large amount of water that can cause them to
stick to the inside of the suction tube. To reduce sticking the material should be left for a few
days to dry out.
Cleaning and Storage
Make sure that all nuts, bolts and screws are tight and that the guards are fitted correctly.
All damaged and worn parts should be replaced in order to maintain the Vacuum-Blower in
a safe working condition.
Never leave material in the Vacuum-Blower or the debris collection bag. This could be
dangerous when starting the Vacuum-Blower.
After use the Vacuum-Blower should be thoroughly cleaned.
Ensure that the Vacuum-Blower is switched off and disconnected from the mains supply.
Remove and empty the debris collection bag. Ensure that the Vacuum / Blow selector lever
operates smoothly and that it is not obstructed by debris. Brush any loose debris from
a r o u n d
t h e
f a n
Do not use any type of cleaning solvent on the plastic parts of the Vacuum-Blower.
a n d
i n s i d e
t h e
s u c t i o n / b l o w e r
EN
t u b e .
