00 . 63 3. 5 096
Operating Instructions:
Control Panel on the Front of Unit:
1. On/Off Main Power Button
a. Press to switch the unit ON/OFF.
b. The unit will turn on to its default factory settings.
2. On/Off Heater Button
a. This allows programming of the thermostat. The fireplace can be used without the heater if desired.
b. Adjust the temperature rating from 62°F - 82°F - ON (17°C - 27°C).
Note: °F is the default unit. To change from Fahrenheit to Celsius: Hold the heater button for approximately
5 seconds, the temperature readout will switch directly from °F to °C and vice versa.
3. Adjustable Flame Brightness
a. Adjust the flame brightness level:F5 - F4 - F3 - F2 - F1 - OFF (F5 being the brightest and F1 the dimmest)
4. Adjustable Log Brightness
a. Adjust the log brightness level: L5 - L4 - L3 - L2 - L1 - OFF (L5 being the brightest and L1 the dimmest)
5. Adjustable Timer
a. This allows you to control the duration of the heater function. Press the timer button until you have reached
the desired duration time. Levels: 30 min - 1H - 2H - 3H - 4H - 5H - 6H - 7H - 8H - 9H – OFF
CHILD LOCK FUNCTION:
This unit is equipped with child lock protection. To activate the child lock function, push and hold the power button on the unit
for 6 seconds. After holding the power button, the log light will blink 3 times to confirm that the unit is in child lock mode.
Once the unit is in child lock mode, the buttons on the unit will not function when pushed. To deactivate the child lock
function, push and hold the power button on the unit for 6 seconds.
ELECTRICAL CONNECTION:
A 12.5 AMP, 120 Volts, 60 Hz circuit with a properly grounded outlet is required. It's recommended that the fireplace be on a
dedicated circuit, as other appliances on the same circuit may cause the circuit breaker to trip or blow the fuse when the
heater is in operation.
1. Power
2. Heater
ELECTRICAL SPECIFICATIONS
Voltage:
Amps:
Watts:
Lighting:
3. Flame
4. Log
120VAC, 60 Hz
12.5Amps
1500 Watts
LED
5. Timer
