Idiomas disponibles
Idiomas disponibles
CONTROL
OL PANEL
Indication symbols on LCD and panel buttons functions
Power control button
Mode selection button
Cooling / Dehumidification/ Fan modes symbols
High / Med / Low fan speed symbols
Indicator of room temperature
Lamp for full water tank:
Display timer setting of auto switch on/off
BEFORE USING THE APPLIANCE
• Check that the power supply at the location where the air conditioner is going to be used is
220-240V ~ 50Hz .
• Make sure that the electrical installation is suitable to supply continuously current necessary
for the air conditioner in addition to that already used by other electric appliances (white
goods, lighting). See the max electric input indicated on the name plate positioned on the air
conditioner.
WARNING: ALWAYS OPEN the AIR OUTLET GRILLE BEFORE USING THE APPLIANCE
• The unit has to be connected according to the local electrical rules.
• Make sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a start-up cur-
rent of 20 A (generally less then 1 second).
• Do not install the air conditioner where it could be wetted by drops of water (i.e. in laundries).
• Make sure that the ON - OFF button switch on the control panel of the air conditioner is
in OFF position.
• Before connecting the air conditioner to a power socket, make sure that the socket is provid-
ed with an earth connection in compliance with local codes.
• Never use the power plug as a mean to start or stop the air conditioner: always use the
ON/OFF button switch on the air conditioner control panel.
• Do not move the air conditioner during operation, turn it off and disconnect the plug from the
power supply. Verify and eventually discharge the condensate water, through the discharge
tube located on the rear of the unit.
• WARNING! Do not stick anything into the air outlet of the air conditioner. This is very dangerous because the fan is rotating at high speed.
• WARNING! The air conditioner is provided with a time-guard system, which does not allow re-starting of compressor until after 3 minutes
from a previous stop.
• Make sure that there are no obstacles around the unit affecting the free circulation of air. Do not block the air intake and outlet of the unit
with curtains or other. Never put objects on the top of the unit. Make sure that the back of the unit is at least 10 cm from a wall.
• The manufacturer assumes no responsibilities if the safety regulations or local codes are not observed.
WARNING
1. Always unplug the unit from the power socket before moving or cleaning it.
2. If the power cord is damaged, it must be replaced by the manufacturer, its service agent or other qualified person to avoid a hazard.
3. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Fan speed slection button
EG
3
