Idiomas disponibles
Idiomas disponibles
RAISING VEHICLE:
1. Make sure the jack and vehicle are on a hand level surface.
2. Always set the vehicle parking brake and block the wheels
3. Consult the vehicle owners manual to ascertain the location of jack points and position the jack
beneath the prescribed lift point.
4. Turn the release valve clockwise to the closed position. DO NOT OVER TIGHTEN!
5. To raise the vehicle to designed height, place the handle into the socket and pump up and down.
6. Place jack stands beneath the vehicle at locations recommended by the vehicle manufacturer. Do
not get under the vehicle without jack stands. Jacks are not designed to maintain heavy loads for
long periods of time. Do not attempt to put jack stand simultaneously under both ends of vehicle
or under one side of vehicle.
7. Turn release valve SLOWLY counter-clockwise to lower load onto jack stands.
LOWERING VEHICLE:
1. Turn the release valve clockwise to the closed position.
2. Pump the handle to lift vehicle off of jack stands.
3. Remove the jack stands. Do not get under or let anyone else under the vehicle while lowering.
4. Turn the release valve SLOWLY counter-clockwise to lower the vehicle onto the ground.
INSPECTION
The product shall be maintained in accordance with the product instructions. No alterations shall be
made to this product.
1. Before each use, a visual inspection shall be made for abnormal conditions such as cracked welds,
damage, bent, worn, loose or missing parts.
2. Inspections shall be performed in accordance with this manual.
3. The product shall be inspected immediately if it is believed to have been subjected to abnormal
load or shock. Owners and / or operators should be aware that repair of this product may require
specialized equipment and knowledge.
MAINTENANCE
Monthly Maintenance is recommended. Lubrication is critical to jacks as they support heavy loads.
Any restriction due to dirt, rust, etc., can cause either slow movement or cause extremely rapid jerks,
damaging the internal components. The following steps are designed to keep the jack maintained and
operational.
1. Lubricate the ram, linkages, saddle and pump mechanism with light oil.
2. Visually inspect for cracked welds, bent, loose, missing parts or hydraulic oil leaks.
3. The product shall be inspected immediately if it is believed to have been subjected to abnormal
load or shock.
4. Any hydraulic jack found damaged in any way, is found to be worn or operates abnormally shall
be removed from service until repaired by an authorized customer service representative.
5. Clean all surfaces and maintain all labels and warnings.
6. Check and maintain the ram oil level.
7. Check the ram every three months for any sign of rust or corrosion. Clean as needed and wipe
with an oil cloth.
8. When not in use, always leave the saddle and ram all the way down.
9. Always store your jack in the fully lowered position. This will help protect critical areas from
corrosion.
10. Do not use brake or transmission fluids or regular motor oil as they can damage the seals. Always
purchased and use products labeled Hydraulic Jack Oil.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
