Idiomas disponibles
Idiomas disponibles
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
2.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
3.
Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or have
it replaced if damaged. DO NOT run pressure washer if
inlet screen is damaged or missing.
4.
Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5.
Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6.
Turn ON the water, press red button (B) on the gun and
squeeze the trigger to purge the pump system of air
and impurities.
B
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
Checklist Before Starting Engine
Review the unit to ensure you have performed all of the
following:
1.
Be sure to read Safety Rules and Operation sections
before using the pressure washer.
2.
Make sure handle is in place and secure.
3.
Attach battery to handle and make the connection.
4.
Check that oil has been added to proper level in engine
crankcase.
5.
Add proper fuel to fuel tank.
6.
Check for proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damage to the high pressure hose.
7.
Provide proper water supply (not to exceed 100°F).
Battery Float Charger
Use battery float charger jack to keep the starting battery
charged and ready for use. Battery charging should be done
A
in a dry location, such as inside a garage.
1.
Plug charger into unit's "Battery Float Charger" jack (C),
which is located next to the key start. Plug battery
charger into a 120 Volt AC wall receptacle.
C
2.
Unplug charger from unit and wall outlet when pressure
washer is being started and while it is in operation.
3.
Keep this charger plugged in when pressure washer is
not in use to prolong battery life. The charger has a built
in float equalizer and will not overcharge the battery,
even when plugged in for an extended period of time.
IMPORTANT: See Battery Maintenance for additional
information.
10
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
