Idiomas disponibles
Idiomas disponibles
EN
20
OPERATION
Close the lid. Set the switch from position
1
1. The unit automatically starts operation.
Note: The spin extractor is equipped with
a special safety mechanism that prevents
the switch from being set to position 1
when the lid is not open. If the centrifuge
starts to wobble during the start of
operation, you must stop the appliance
by setting the switch to 0, improving the
weight distribution of the clothing and
restarting the appliance.
2
When the spin dryer starts, water from
the drain starts to run. Do not forget
to place a container under the drain to
collect the water. When the water stops
flowing from the drain (after about
2-3 minutes, depending on the type of
clothing), you can turn the appliance off
by setting the switch to the 0 position.
3
Open the cover (2) when the drum (4)
has come to a complete stop. A safety
mechanism prevents the lid from being
opened while the drum (4) is still rotating.
Do not attempt to force the cover open.
Note: After plugging in the plug, the drum may rotate very slowly for 10
seconds, even if you have not switched on the unit. This is neither a defect
nor a safety risk as the drum rotates very slowly. This is caused by any
residual voltage in the built-in capacitor.
