Idiomas disponibles
Idiomas disponibles
Connecting Drain Hose
Before connecting Drain Hose, check your Drain Hose model and choose the correct instructions.
Pump Model
1
Insert the plastic holder into hole
in the back side toward the stand
pipe direction. Adjust the holder
by pressing the both sides to
push in.
2
Push the end part of the drain hose in the
outlet of the drain pump and tighten with
the clamp to fit in.
3
Insert the open end of the drain hose into the standpipe
or wash tub. To prevent the hose from dislodging and
falling. Fit the curved holder to the hose and secure it
to the stand pipe or laundry tub.
Caution
• The outlet should be placed 0.9-1.2m higher than the floor.
• To prevent siphon, the drain hose should not be extended more
than 50mm from the end of the hose guide.
• The hanging down drain hose might cause poor drainage.
Non-Pump Model
1
Before connecting
Ensure that the hose clip is set as indicated here.
2
Connect the Elbow Hose
Push the elbow hose toward the body of the
washing machine.
3
Place the Drain Hose
To change the direction of the hose, pull out the
elbow hose and change the direction.
Repeat Step 2.
32
Holes
Bottom
For Holder
Within 50mm
Hose
Guide
0.9-1.2m
Clip
