Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
Dear Customer,
You have made a good choice by buying one of our brand-name products. To enjoy the product
for as long as possible and ensure safe handling, please be sure to observe the setup and usage
instructions on the following pages. Our products are regularly inspected to ensure that they meet
the desired high quality standards and, of course, always comply with the stringent requirements
of the European Union. Even the best products can be subject to defects, e.g. due to external
factors. We stand by our quality promise and offer you the best possible service. If a problem does
occur, please contact our trained staff regarding all service matters, complaints and technical
support.
IMPORTANT!
Please read the instructions thoroughly and in their entirety before using the product for the first
time. Keep these instructions for future reference. Should you pass the product on in future, ensure
that you also include these instructions.
CAUTION! POTENTIAL DANGER!
Observe the safety information and setup instructions to avoid the risk of injury or damage to the
product.
RISK OF SUFFOCATION!
Keep small parts and packaging material out of the reach of children!
PRODUCT MODIFICATION
Never make modifications to the product! Modifications will invalidate the warranty and the
product may become unsafe or, in the worst case scenario, dangerous.
SAFETY INSTRUCTIONS
The solar-powered welding helmet with automatic dimming is suitable for most welding tasks.
Thanks to a switching time of 0.1-1 seconds, the lens of this helmet darkens automatically as soon
as welding is started. Independently of the colour tone to which the filter is set, the UV/IR
protection is always safeguarded. ARC rays may damage the eyes and burn the skin.
• Always check the helmet and the automatic anti-glare cassettes (Auto Darkening Filter or ADF)
to ensure that they have been attached properly and in good condition prior to welding.
• Keep the sensors, the solar cells and the filter lens clean. Clean the filter cartridge with a soapy
water solution and a soft cloth. Do not use solvents or weld in the overhead position while
wearing this helmet.
• Check the filter lens on a regular basis and immediately replace all scratched, cracked or
corroded filter or cover glasses. Always wear safety goggles beneath the welding helmet and
protective clothing to protect your skin from radiation, burns and splashes.
• Do not allow any moisture to enter the device, in order to protect it from damage.
• Do not expose the device to direct sunlight.
• Use symmetrical force to adjust the electrograph. Do not turn using force.
• Test the batteries before use. If the battery no longer has sufficient charge, it is not guaranteed
that the helmet can switch.
EN
9
www.DEUBAXXL.de
