YATO YT-83080 Manual Original página 12

EN
Using the product for starting vehicles
Prepare the product by charging to full capacity.
Connect starting wire clamps to battery terminals. Pay attention to the correct polarity. Clamped indicated by "+" symbol
should be connected to battery terminal indicated the same way. Clamped indicated by "-" symbol should be connected
to battery terminal indicated the same way.
Connect the plug of starting wires to a slot matching the plug. The shape of a plug allows connecting in just one, proper
way. Do not apply excessive force when connecting the plug of starting wires to the product.
Start the vehicle. If a vehicle fails to start within 2 seconds, wait at least 30 seconds before you try again. The brake is
indispensable to cool down the product and starting wires.
After a vehicle has started, disconnect the plug of starting wires from the product within 30 seconds, without stopping
the engine, and then disconnect starting wire clamps from battery's terminals.
Warning! Due to its lower capacity, YT-83080 product should not be used as a starting device in case of vehicles fi tted
with engines over 2500 cm capacity.
3
Note! The capacity of product's battery allows starting of approx. 20 vehicles.
Using the product to charge mobile devices
Before charging the device, please check in the documentation provided with the device whether charging by means
of power banks is allowed.
Connect one of the plugs to the charging slot of the mobile device to be charged.
Connect the second cable plug to one of the USB slots of the product marked with "OUTPUT/WYJŚCIE".
In case of YT-83080 product, charging process starts automatically.
In case of YT-83081 product, charging process starts after unlocking and pressing the switch. Repeated movement of
a lock stops charging process.
In the course of charging portable devices, product charging indicator diodes light, indicating the status of charging of
product's battery.
The charging process will begin.
Current output of the slot is specifi ed in the technical data table.
In products fi tted with many slots it is possible to charge many devices from product's slots at the same time.
After charging is complete, disconnect the plug from the USB slot of the product and then from the device being
charged.
The product has a battery of the capacity specifi ed in the technical data table, which indicates that it may fully charge
only devices with a smaller battery capacity than the battery of the product.
Connecting for charging a device fi tted with a battery with a higher capacity than the product's battery will not allow the
battery of the device to be fully charged.
In the course of charging, portion of energy of the product's battery is lost due to the heat release. This is a normal
phenomenon that makes it impossible to assume that a product will fully charge a device with the same battery capacity
as the product's battery.
Using the product's fl ashlight.
The product is fi tted with LED diode that may be used as a fl ashlight providing additional lighting of a small surface
or as a signalling light. Diode lights up after pressing and holding down a switch for approx. 2 seconds. In case of
YT-83081 product, fi rst the switch should be unlocked.
Diode is switched off after pressing and holding down a switch for approx. 2 seconds.
Pressing the switch when the diode is lighting will change the lighting mode in the following sequence: continuous light,
fl ashing, alarm fl ashing, switching off .
While alarm fl ashing the diode emits SOS signal encoded in Morse alphabet.
When the diode is lighting, also product charging indicator's diodes light, indicating the status of charging of product's
battery.
Product maintenance
The product does not require any special maintenance procedures. The product housing should be cleaned using a soft
12
O R I G I N A L I N S T R U C T I O N S