Installation - Dometic DTD01 Manual De Instrucciones

Dometic Tank Discharge Control
Maximum relay rating for 12 or 24 V DC discharge pump: 20 amps .
Float Switch Rating: 20 watts with resistive load (when used with DTM04 system) .
5.3 Dimensions
Ref. Dimension
A 83 mm (3 .25 in .)
B 83 mm (3 .25 in .)
5.4 Approvals
ISO8846; EMC Directive 2004/108/EC
6

Installation

6.1 Tank Discharge Control Panel
Caution!
Do not install DTD control panel in an atmosphere with potentially flammable or
explosive vapors.
1 . Select panel location away from direct contact with
water and oil .
2 . Confirm clearance for wire connections behind wall,
hull liner or bulkhead .
3 . Using control panel template (fig . 8 , page 11), cut out
panel access hole (E, F) and drill fastener holes (G) .
4 . With electrical power off, route 14-gauge stranded copper
wire from power source, through discharge pump circuit
breaker or fuse (not provided), to panel location . Route
additional wire according to diagram on page 3 or 4
(see wiring diagram keys below), depending on your
application, to panel location . Make sure wires extend
out through access hole .
5 . Make proper wiring connections to wires extending from
bottom of circuit assembly (fig . 2 4, page 2) .
6 . Remove panel cover (fig . 2 1, page 2) from mounting
frame (2) by carefully pulling them apart . Make sure wires
between key switch (3) and circuit assembly (4) remain
attached . (Key pin 1 – red; pin 2 – brown; pin 7 – blue .)
7 . Install mounting frame to wall with four fasteners (5) .
8 . Tuck key switch wires into circuit assembly housing,
and push panel cover onto mounting frame until it
locks into place .
9 . Turn on electrical power .
(fig . 3 , page 2) 3
8
2
2
Ref. Dimension
C 51 mm (2 in .) clearance behind wall
D 10 mm (0 .38 in .)
(fig . 2 , page 2) 2
Control Panel Template
Dimensions
Specifications
(fig . 8 , page 11)
8
Ref. Dimension
A 83 mm (3 .25 in .)
B 83 mm (3 .25 in .)
C 67 mm (2 .63 in .)
D 67 mm (2 .63 in .)
E 55 mm (2 .16 in .)
F 68 mm (2 .69 in .)
G 2 mm (0 .10 in .) dia .
H Cut-out area .
Allow 51 mm (2 in .)
clearance behind wall .
7