Cameo ZENIT B200 Manual De Usuario página 13

Ocultar thumbs Ver también para ZENIT B200:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57
DMX Fail
=
Operating status with DMX
signal fault
AC Failure
=
Operating status in the event
of a power failure
Dimmer Curve
=
Dimmer curve
Dimmer Response
=
Dimmer sensitivity
Color calibration
=
Color calibration
(If one of the DMX factory
calibration modes is activat-
ed, no other calibration can
be selected and the message
"no possible change in this
DMX Mode" will be shown
on the display. If one of the
DMX user calibration modes
is activated, RAW can be
selected as the alternative
calibration.)
Autolock
=
Automatic locking of the
controls
LED Frequency
=
LED PWM frequency
IR Remote
=
Activate or deactivate control
by IR remote control
Factory Reset
=
Reset to factory settings
Hold
Last command is retained
Blackout
Activates blackout
Full On
All the LEDs have 100% output
Stand Alone
Spotlight switches to the last selected stand-
alone mode
No Action
Last command is retained
Blackout
Activates blackout
Full On
All the LEDs have 100% output
Stand Alone
Spotlight switches to the last selected stand-
alone mode
Linear
Light intensity increases linearly with DMX value
Exponential
Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher DMX
values
Logarithmic
Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values
S-Curve
Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted at
medium DMX values
LED
Lamp responds abruptly to changes in DMX value
Halogen
Lamp behaves like a halogen spotlight with soft
brightness changes
RAW
R, G, B and W with maximum value 225
User calibration
Individual colour calibration. Cross-mode bright-
ness setting of the 4 LED groups RGBW with
values from 000 - 255
Factory calibration
Factory-default calibration of R, G, B, and W
(across all operating modes). Select this setting
to ensure the consistent-looking presentation of
color macros in stand-alone mode and to control
color macros with DMX
On
Automatic locking of the controls after approx-
imately 1 minute of inactivity. Display shown
upon attempted use: "Locked!" To unlock: Press
and hold UP and DOWN simultaneously for
approx. 5 seconds
Off
Automatic locking of the controls is disabled
800Hz / 1200Hz /
Configuration of LED PWM frequency
2000Hz / 3600Hz /
12kHz / 25kHz
On
IR remote control activated
Off
IR remote control deactivated
Reset Now!
Reset to factory settings:
Confirm with ENTER. Cancel with MODE
13
Tabla de contenido
loading

Este manual también es adecuado para:

Clzb200

Tabla de contenido