Blaupunkt TV Tuner 04 Instrucciones De Manejo página 14

Controls
1 POWER button to switch the device
on/off.
2 PROG CH
,
stored stations from the memory loca-
tions.
3 SEARCH CH
station seek tuning up/down. To adjust
set values: +, -.
4 Recall button to call up the station
saved last with MEM.
5 AUDIO button to set the audio level for
the TV tuner and a video source con-
nected to the tuner.
6 TRAVEL STORE button for automati-
cally seek tuning and storing receivable
stations.
7 SOURCE SEL VIDEO button for video
source selection. If a video source is
connected, it is played back.
8 SOURCE SEL TV button for the TV tun-
er source selection.
9 BAND button for mode switching be-
tween terrestrial reception and cable
network.
: FINE TUNE button for manual fi ne tun-
ing of stations.
; MEM button for storing a station at a
memory location 0 - 9. 70 stations can
be stored for terrestrial reception and
56 for the cable network.
< Numeric buttons 0 - 9 for the direct
selection of stations.
= DISP button shows, for example, the
current settings on the monitor or spe-
cial settings if operated in the Coach
system.
14
buttons to call up
, buttons to start
> MUTE button to mute the car sound
system.
? A/V Output – Video socket to con-
nect a monitor or for integration in an
ex isting Coach system.
@ A/V Output – Audio socket to con-
nect an amplifi er or for integration in
an existing Coach system.
A 6-pole Molex socket to connect the
TV tuner to a CCA or CPA amplifi er.
B 3-pole Molex socket 12/24 VDC for the
voltage supply.
C 2.5-mm IR Remote jack socket to con-
nect a cable remote control.
D 4-pole Molex IR Remote socket to con-
nect the IR receiver for the remote con-
trol.
E A/V Input – Audio/Remote socket to
connect an external video source, e.g.
DVP. This socket is used to conduct the
audio signals from the video source to
the TV tuner and the signals of the re-
mote control to the video source.
F A/V Input – Video socket to connect a
video source to the TV tuner.
G TV IN socket to connect an antenna to
the TV tuner.
H 6-pole Molex plug to connect to the
Classic Line system (source selection/
cable remote control)
I 3-pole Molex plug to establish a power
supply.
J Infrared receiver for the remote control
with 4-pole Molex plug.