Brigmton BHCP-2009 Manual De Instrucciones página 9

Idiomas disponibles

Idiomas disponibles

-do not use chemically de-limed water or perfumed
5. Do not store the iron with water in the tank.
Steam ironing
1. Fill the iron as described in the section "how to fill the water tank".
2. Plug the iron into the mains.
3. Steam ironing is only possible when the highest temperatures shown on the temperature control are selected.
Otherwise, water may escape through the soleplate.
4. Wait until the pilot light goes out, which indicates that the selected temperature has been reached.
5. Turn the steam button to the required position.
6. When the ironing is finished and during breaks in ironing, place the iron in its upright position.
7. Disconnect the iron from the mains supply. Pour of any remaining water and leave the iron to cool off.
Spray
1. The spray can be used in any position, either in dry or steam ironing, as long as the water tank is filled with water.
2. Press the spray button for this function
NOTE: This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the "max" position and wait until the pilot light goes out
2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE: For the best steam quality, do not use more than three successive bursts each time. Several pumping actions are
needed to start this function.
Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before operating the
shot of steam control
Cleaning
1. Disconnect the appliance from the mains, before cleaning.
2. Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.
Defects and repairs
Do not attempt to replace a defective mains lead. The appliance has to be returned to an authorized service centre for
repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture need to be burnt off allow ten
minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt, AC electrical outlet only. The temperature dial must be set at the desired
temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to "0" and add water .Allow the iron to heat, and then set the steam
dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should be in the horizontal
position. Prime pump briefly. Allow a short pause between shots. Be sure to fully depress the burst of steam button.
Spry mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section "how to fill the water tank".
Iron is leaking
The variable steam dial must be set "on", until the iron is hot. The temperature setting is too low to produce steam. Shot
loading