Idiomas disponibles
Idiomas disponibles
Safety recommendations and precautions
Important precautions
To make good use of your appliance, please read these instructions carefully and look at the illustrations before using it.
1. Check that the voltage on the product rating plate coincides with your mains voltage.
2. The iron shall not be used if there are visible signs of damage or if the iron in leaking .The iron shall be sent to the
manufacturer or his qualified service agent before further use.
3. Completely unwind the mains cable.
4. Always unplug the iron when not in use, even if only for a short period of time.
Unplug it from the mains and leave it standing on its rear base.
5. Make sure that children can not touch the hot iron and that they can not pull on the mains wire.
6. Always unplug the iron before filling the water or when removing the excess water form it.
7. Never submerge the iron in water.
8. The iron shall be used on a stable ironing board.
Special instructions
1. Model:HJ-8020
Mains Supply:220V-240V~50Hz
Rated Power:2200W
2. To avoid overloads, do not plug any other high-power appliance into the same electricity line.
Suggestions before using the iron for the first time
1. Certain parts of the iron have been lightly greased therefore the iron could give off a little smoke when plugged in for
the first time. This will cease after a short while.
2. Before using the iron for the first time, remove the plastic protector from the base (if it has one) clean the base with a
soft cloth.
3. Keep the base very smooth. Do not run it over metal objects (such as against the ironing board, buttons, zips, etc.)
4. Pure wool fibres (100% wool) can be ironed with the appliance in the steam position, by preference, select a high
steam position and use a dry ironing cloth.
Selecting the temperature
1. Check the ironing instructions on the garment to be ironed.
2. If the garment does not have any ironing instructions but you know the kind of fabric in question, use the chart below.
3. Fabrics that have some kind of finish (polishing, wrinkles, contrasts...) can be ironed at the lowest temperatures.
4. If the fabric contains several kinds of fibres, always select the temperature applicable, if an article contains 60%
polyester and 40% cotton, you must always choose the temperature corresponding to polyester and without steam.
5. First classify the articles to be ironed according to the most suitable ironing temperature: wool with wool, cotton with
cotton, etc. as the iron heats up as fast as it cools, start by ironing the articles requiring the lowest temperature such as
those made of synthetic fibres. Progress towards those that require the highest temperatures.
6. Turn the temperature control until it is in front of the appropriate signal according to the following:
· position for nylon and acetate
· · position for wool, silk or mixures
· · · position for cotton or linen (steam).
How to fill the water tank.
1. Unplug the iron.
2. Set the steam ruler to dry ironing.
3. Fill the tank through the filling hole.
4. If you have hard water, it is advisable to use only distilled or demineralized water.
