Idiomas disponibles
Idiomas disponibles
EN
6. maintenance and storage
WARNING
After servicing, ensure that all guards, shields and safety features are put back in place. Failure to comply with this
warning can result in serious injury. Improper maintenance and storage of the log splitter may void the warranty.
MANTINANCE
•
Before servicing, the log splitter must be placed in maintenance mode. Shut off the engine and move the control lever back
and forth to relieve hydraulic pressure.
•
After performing any maintenance, ensure that all guards, shields and safety features are put back in place before ope-
rating the log splitter.
•
Before operating, ensure that the tyres have the RECOMMENDED TYRE PRESSURE.
•
Regularly grease the axle and wheel bearing area or when necessary.
•
After greasing wheel bearings, make sure axle nuts and pins are in place and secure.
•
Periodically check all fasteners and hoses for tightness and leaks.
•
Clean and lubricate all moving parts annually or as needed.
•
Use a gloss enamel spray paint to touch up scratched or worn painted metal surfaces.
•
Never exceed the load capacity of 22 tons, it will damage the log splitter.
What
Whips
Hydraulic connectors
Nuts and bolts
Beam
Moving parts
Consulte el Manual del propietario del motor para el mantenimiento del motor
IMPORTANT
Si una pieza necesita reemplazo, solo use piezas que cumplan con las especificaciones del fabricante. Las piezas de
repuesto que no cumplan con las especificaciones pueden ocasionar un riesgo de seguridad o malas operaciones.
STORAGE
Before storing, make sure the log splitter is clean and dry for years of trouble-free service.
- Lightly lubricate all log splitting surfaces and moving parts to prevent rusting.
- Store indoors or in protected areas during severe weather and winter months.
When
Inspect exposed wire mesh and for leaks. Replace all worn or dama-
Every use
Inspect for cracks and leaks. Replace all damaged connections
Every use
Every use
Every use
Cada uso
How
ged hoses before starting the engine.
before starting the engine.
Check for loose screws
Apply grease to the beam surface.
Cleaning up waste
46
